Stertil Hydraulic Dock Levelers with Access Doors & Dock Bumpers - 2958

Quantity available: 2

Loading Bay Dock Levelers With Dock Levelers + Access Doors + Dock Bumpers

Technical Specification

Electrically controlled Hydraulic Dock Leveller with hinged lip. 

Overall Width - 210 cms (2.1 mts) & Overall length - 260 cms (2.6 mts) with Lip stretched out

Model - fitted with a 500mm long hinged lip. 

Rated loading capacity 6000Kg.single axle loading (based on the EN1398 statement that 100% of the load to be calculated on the front axle), 9000Kg static load.

The top plate, lip and "T" beam sections are manufactured from FE –510D high tensile steel. A 4-point hinge system at the rear of the platform is to provide support and stability.Brush weather seals. Panic-Stop facility to prevent freefall in the event of vehicle pull away. Emergency stop to comply with EC directives. Integral fixed maintenance support strut and full range safety toe guards. 

Doors and dock levelers to be operated from a combined single control panel.

Dock Bumpers

Below each dock access 2-no heavy duty rubber dock bumpers (450mm x 200mm x 150mm deep) bolted to 10mm thick plates cast into dock face for added strength.

Level Access Doors

Doors are of Thermadoor 640 and consist of electrically operated insulated vertical lift with low level springs for ease of maintenance. The rigid panels to be manufactured from two skins of galvanised steel, infilled with expanded polyurethane foam. A continuous thermal break is to be provided between inner and outer skins.  Finger trap protection to panel joints inside and outside.  EPDM seals to be fitted to the top, bottom and sides of the door to prevent rain penetration and minimise draughts. 

Size to give a clear opening 2860mm wide x 3000mm high ( Note: structural steel size 3000mm wide x 3070mm high if 70mm insulated cladding returns around door jambs/soffit).

Energy absorbing polyethylene low fiction PE 450 dock bumpers incorporating rubber shock absorbers to reduce collision damage. The special front face to be manufactured from ultra high molecular polyethylene which can be simply rotated on site and interchanged to give four times the life of each bumper.  All fixings to be located in the rear plate to ensure a flat front surface.  The bumpers to project 150mm and will be located on both sides of the dock leveller to prevent vehicle contact and possible damage to the building structure

Manufacturer

Stertil United Kingdom

Type

Loading Dock Level